Barkbusters Two Point Mount – Handguard Protector – BLG-013-00-NP

Barkbusters Two Point Mount – Handguard Protector – BLG-013-00-NP

• AUSTRALIAN MADE – “Aussie Made Aussie Tough”
• Designed specifically for the DUCATI Multistrada 1200 (’10 to ’14) with OEM (Original Equipment Manufacturer) specifications.
• Two mounting points secure the full wrap-around aluminum design.
• It seamlessly integrates around the original Ducati handguard and controls.
• The heat-treated aluminum backbone for added strength and impact protection (backbone powder-coated BLACK).
• Bar end weights included.
• Easy installation.
• Backbones only ( NO guard options ).

CAUTION: Installation of the handguard is safety-relevant work and can be complicated. We recommend the installation be performed by a motorcycle service technician. Rideworx accepts no liability for damages caused by improper mounting. All screws, bolts, and nuts, including all replacement hardware provided by Rideworx, should be tightened to the torque specified in the table. After the first 50km of riding check all screws, bolts, and nuts are tightened to the correct torque. We recommend a medium-strength liquid thread lock product on all fasteners. WARNING: Check the operation of all handlebar controls, specifically the throttle, front brake, kill switch, and clutch to ensure they are operating correctly and are by the OEM specifications. Do not ride the motorcycle if any controls are not operating correctly. Check periodically that all bolts are tight.

Important Fitting Procedure Remove the original Ducati handlebar end caps. Installation is shown for the RIGHT side. Repeat for the left side with applicable parts. Loosely assemble the clamp to the handlebar (see diagram). Attach the handguard backbone with applicable parts to the handlebar end and the clamp. Tighten all bolts in the following order using the recommended torque specifications over the page. Tighten bolt (9) into the handlebar end. Tighten bolt (2) through the aluminum bar (1) to the clamp connector (7) of the clamp assembly. Tighten bolt (5) to solidly lock the clamp connector (7) between the clamp saddles (3). Tighten bolt (4) to secure the clamp assembly firmly to the handlebar. Note: The clamp is designed to allow the nut on bolt (5) to pull into the recessed hole. This eliminates the need for a wrench after the bolt starts to tighten.

Disclaimer: A failure to follow these fitting instructions could cause serious injury, death, or property damage. These handguards are intended solely for use withmotorcyclessAATV snowmobiles/scooters that have not been modified. They are not designed to prevent injury or death while riding or in an accident or crash. The user must ensure that all controls are free of the handguards every time that they ride. By installing and/or using this product you acknowledge that you accept these terms and have followed the fitting instructions.

NOTE: Barkbusters Lever Guard is to be mounted in conjunction with original DUCATI plastic handguards. When mounted correctly, indicators should not be obscured.

Instructions

• INS-BLG-013-00-NP

To fit:
DUCATI Multistrada 1200 (’10-’14)

Brand

Shipping is usually done in 2 working days after receiving order. If need express shipping contact our team at 8962258899. If you are making backorder or product is in pre-order state then it will be shipped when we get new stocks.

Once order is shipped and not received when delivery attempt is made, it will come back to us. In such case of RTO (Return to Origin), shipping cost of return and reshipping is to be born by Customer. Once order is shipped tracking details are shared on email and also can be checked in your website account. In any case of delay in delivery due to shipping service provider, we will not be liable. You need to contact shipping service provider.
Some Products are made on order, so may take time of 7-10 days.